C&K systems SYSTEM 2316 Installation Manual page 10

SYSTEM 2316 Installation Manual
Command Location 0B: Communications Control
Default Values
Digit Position (1): Delay Before Dial Time
0 = 0 secs 4 = 40 secs
1 = 10 secs 5 = 50 secs
2 = 20 secs 6 = 60 secs
3 = 30 secs 7 = 70 secs
Digit Position (2): Dial Type
1 = DTMF - Touch Tone (10/sec)
2 = DTMF (5/sec)
3 = Pulse (10/sec)
Digit Position (3): Enable Keypad Activated RPS
0 = No
1 = Yes; allows remote programming to start from on-site keypad command
Digit Position (4): RPS Enable
0 = No
1 = Yes; allows remote programming to start from off-premise location
Digit Position (5): Phone Ring Type
0 = Single ring; uniformly timed rings with long pauses between rings
1 = Double ring; rings twice quickly followed by a long pause then rings twice again
Digit Position (6): Dialing Attempts
1 = 1 try
5 = 5 tries
2 = 2 tries 6 = 6 tries
3 = 3 tries 7 = 7 tries
4 = 4 tries 8 = 8 tries
Command Location 0C: Account Number 1
Account Number 1 is used in
conjunction with Receiver Number 1
Digit Positions (1) - (6): Account Number
Valid entries are 0 - F.
The Account Number is right justified. The last digit must be in Position (6).
The SYSTEM 2316 will read the account number using:
Digit Positions (4) - (6) with 3-digit accounts
Digit Positions (3) - (6) with 4-digit accounts
Digit Positions (1) - (6) with 6-digit accounts
Fill all unused Digit Positions with 0's.
8 = 80 secs 2 = 120 secs
9 = 90 secs 3 = 130 secs
0 = 100 secs 4 = 140 secs
1 = 110 secs 5 = 150 secs
9 = 9 tries 3 = 13 tries
0 = 10 tries 4 = 14 tries
1 = 11 tries 5 = 15 tries
2 = 12 tries
Default Values
NOTE: Some keypads may have a
an [ENTER] key in place of the [*] and [#] keys,
respectively. This manual uses the [*] for the [SHIFT]
key and the [#] for the [ENTER] key.
0 3
0 B
(1) (2)
0 0
0 C
(1) (2)
Hexadecimal Value
[SHIFT] key and
10
CL 0B and 0C
1 1 0 8
(3) (4) (5) (6)
0 0 0 0
(3) (4) (5) (6)
PROGRAMMING CONVERSIONS
Key Strokes
A
B
C
D
E
F
#
#
0
1
2
3
4
5