Table of Contents
Advertisement
Command Line Interface
General Setup Commands
nwdbg dtmf_relay <0|1>
Definition:
Parameter(s):
Example:
nwdbg mac <MAC ADDRESS>
Definition:
Parameter(s):
Example:
nwdbg ip <dhcp|bootp|manual>
Definition:
Parameter(s):
Example:
This command turns the Dual Tone Multiple Frequency
(DTMF) relay function on or off, or shows the DTMF relay
state if only nwdbg dtmf_relay is typed.
<0 : off, 1 : on>
nwdbg dtmf_relay 0
This command sets the MAC address of the voice link,
or shows the MAC address if only nwdbg mac is
typed.
<MAC ADDRESS, the format is XX:XX:XX:XX:XX:XX>
nwdbg mac 00:50:ba:08:24:56
This command sets the software boot mode to DHCP,
BOOTP, or Manual mode. If only nwdbg ip is typed, this
command shows the IP configuration.
DHCP: While the system is booting, the system acts as
a DHCP client.
BOOTP: While the system is booting, the system acts
as a BOOTP client. This mode is used to set the device's
IP address and upgrade the software.
Manual: While the system is booting, the system uses a
fixed IP address. The fixed IP address can be set by
nwdbg ip <IP ADDRESS>.
<dhcp|bootp|manual>
nwdbg ip dhcp
70
Advertisement
Table of Contents
