Using The Boot Menu; Configuring The Ip - D-Link DG-102SH Manual

Voip station gateway

Hide thumbs Also See for DG-102SH:

Table of Contents

Using the Boot Menu

To access the Boot Menu, you must first make sure the console is connected

to the Diagnostics port (an RS-232 port with a 9-socket D-shell connector and

DCE-type wiring) and the appropriate cabling for the connection is being used.

Please see the previous section, "Configuration," for additional information. Next,

power the device on by simply plugging it in. You will see the POST test and the

boot up process. During this process, press <Ctrl+C> to reach the Boot Menu.

If the boot up process has proceeded too far and the Boot Menu shown below

does not appear, unplug the device, plug it back in (to restart the boot up pro-

cess), and press <Ctrl+C> until the Boot Menu appears.

This screen allows you to enter information necessary for the initial configura-

tion of this device.

Use the <Tab> key to highlight the first menu item on the Boot Menu, Configure

IP, and press <Enter>. The IP Configuration screen will be displayed:

Boot Menu—Opening screen

Table of Contents