D-Link DFL-1600 User Manual page 298

278
Example:
This example describes how to configure a DHCP server on the internal
interface (LAN)(Refer to 9.1.2, Ethernet Interfaces in D-Link Firewalls).
WebUI
:
Configure DHCP Server
System
DHCP Server:
Enter the following:
Name: dhcpserver lan
Interface Filter: LAN (The interface(s) to listen for DHCP requests
on)
IP Address Pool: 192.168.1.10-192.168.1.20 (The pool of IP ad-
dresses to hand out)
Netmask: 255.255.255.0 (Specify the netmask to hand out)
Options
Default GW: Specify the default gateway to hand out to DHCP
clients. In this case (None).
Domain: Specify the domain to hand out. This can be left empty.
Lease Time: Configure the time a lease should be valid.
DNS: Configure the DNS server information to hand out to DHCP
clients. This can be left to (None).
NBNS/WINS: Configure the NBNS/WINS server information to
hand out to DHCP clients. This can be left to (None).
Next Server: Specifies the IP address of next server in the boot
process, this is usually a TFTP server. This can be left to (None).
Custom Options
Here you can add custom options to the DHCP lease. It is possible to
specify the code, type and parameter.
When finished, click OK
Configuring the firewall as a DHCP server
DHCP Settings
D-Link Firewalls User's Guide
Chapter 26. DHCP Server & Relayer
DHCP Server Add