D-Link DFL-1600 User Manual page 84

64
Example:
This example describes how to configure a PPPoE client. The PPPoE
client is configured on the WAN interface and all traffic should be routed
over the PPPoE tunnel.
WebUI
:
PPPoE Client
We will configure the PPPoE client on the WAN interface.
Interfaces PPPoE Tunnels
Enter the following:
Name: PPPoEClient
Physical Interface: WAN
Remote Network: 0.0.0.0/0 (all-nets, as we will route all traffic into the
tunnel)
Service Name: If your service provider has provided you with a service
name, enter the service name here.
Username: The username provided to you by your service provider.
Password: The password provided to you by your service provider.
Confirm Password: Retype the password.
Authentication
It is possible to specify exactly which protocols the PPPoE client should try
to authenticate with. We keep the default settings for authentication.
Dial-on-demand
Enable Dial-on-demand: Disable
Advanced
If "Add route for remote network" is enabled, a new route will be added for
this interface.
Then click OK
A PPPoE Client configuration
D-Link Firewalls User's Guide
Chapter 9. Interfaces
Add PPPoE Tunnel: