Setting The Beep - Clarion VRX775VD Owner's Manual & Installation Manual

Basic Operations
Warning display when CCD camera
is installed
The following warning message is displayed
during use of the CCD camera: "Make sure of
safety around your vehicle".
2-1. Touch the [ON] or [OFF] key of the
CAMERA WARNING item to turn this
function on or off (The factory default setting
is "ON").
Switching the VTR system between
NTSC and PAL
Note:
• This setting is applied only to the VISUAL/VTR
input mode.
2-1. Touch the [NTSC] or [PAL] key of the
NTSC/PAL item to set the VTR system (The
factory default setting is "NTSC").
Changing the color of the
background picture
2-1. Touch the []] key of the WALL COLOR item
to display the WALL COLOR screen.
2-2. Touch the desired Color you wish to set
(The factory default setting is "CYAN").
Turning on/off the motion of the
background picture
2-1. Touch the [ON] or [OFF] key of the MOTION
item to set the function (The factory default
setting is "ON").
Front monitor lock
When an external device is connected to the
Visual terminal, lock the front monitor to show the
visual input source.
Note:
• This function is enabled only when the CONNECT
item of the GENERAL menu is set to other than
"NONE".
1. Press the [MAP] button to set the monitor
lock.
The front monitor screen is locked to show the
visual input source.
2. To cancel the monitor lock, press the [MAP]
button.
The screen returns to show the image of the
selected mode.
Adjusting the GENERAL
1. Press the [ADJ] button, then touch the
[GENERAL] key.
* The [ADJ] buttons is enabled only when the
panel is open.
2. Touch the [C] key to display the next menu
screen if desired.
3. Perform the adjustment for the desired item.
See the following sections for detail.
4. Touch the [Back] key to return to the previous
screen.
* In the following sections, only the details
regarding adjustments are described,
procedures to select items are skipped.

Setting the BEEP

The sound heard when you make operations is
called "beep". The unit can be set up so that it
does not produce this beep sound.
• The factory default setting is "ON".
3-1. Touch the [ON] or [OFF] key of the BEEP
item to turn the function on or off.
Setting the Blink LED
You can set the unit to blink the LED indication
when the DCP (Detachable Control Panel) is
removed.
3-1. Touch the [ON] or [OFF] key of the BLINK
LED item to turn the function on or off (The
factory default setting is "OFF").
27