Plumbing Connections - Champion DH-1000 Installation Manual

1000 Series HT - Installation Guide
Installation Guide

Water Connection (1000 Series HT
1. Locate the built-in stainless steel booster on the left-side of the dishwasher.
The existing hot water supply lines to the dishwasher must be 3/4" NPT or larger. To the best of
your ability inspect, and verify that all supply piping meets the 3/4" NPT requirement.
The installing plumber must connect a water supply line to the dishwasher that is equal to or
greater than 3/4" NPT in size and a 3/4" pressure regulating valve, PRV,
Dishwasher water supply temperature
and water pressure requirements:
140°F/60°C minimum for 40°F/22°C rise booster
3/4" NPT hot water supply (140°F/60°C minimum)
20 ± 5 psi/138 ± 35 kPa flow pressure.
Installation of 0-60 psi/0-414 kPa pressure gauge
(supplied by others) is recommended.
110°F/43°C minimum for 70°F/39°C rise booster
3/4" NPT hot water supply (110°F/43°C minimum)
20 ± 5 psi/138 ± 35 kPa flow pressure. Installation
of 0-60 psi/0-414 kPa pressure gauge
(supplied by others) is recommended.
2. Connect a 3/4" NPT hot water supply to the dishwasher at the line strainer.
6
and a 0-60 psi/0-414 kPa pressure gauge (not supplied)
)
Note:
Note: