Table of Contents
Advertisement
DIP Switch 10 enables/disables 802.1Q VLAN Tag priority feature.
When the DIP Switch is set at "Enable", the Switch will check each
received data packet and handle the packet according to the VLAN
tagging priority information.
Note: It is ok to enable all three QoS features, but the Port-Based QoS
supersedes the IP header and VLAN Tag features.
C
ONNECTING
This chapter describes how to connect the Switch to your Fast
Ethernet network.
PC to Switch
A PC can be connected to the Switch via a two-pair Category 3, 4, 5
UTP/STP straight cables. The PC (equipped with a RJ-45 10/100Mbps
phone jack) should be connected to any of the 16 ports (1x - 16x)
Note: Use CAT5 (or better) cable for 100Mbps connection.
After the connection is made, the port LED on the Switch will show
the status of the connection. If LED indicator does not light after
making a proper connection, check the PC LAN card, the cable, the
Switch, and the Switch port.
The following are the possible LED indicator status for PC to Switch
connection:
1.
The "LINK/ACT" LED indicator lights green for 100Mbps
connection or lights amber for 10Mbps connection.
2.
The "FDX/COL LED" indicator lights green if the LAN
adapter is in full-duplex mode. The LED remains off when
T
S
HE
WITCH
22
Advertisement
Table of Contents
