Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Smeg TRA90GMP
Summary of Contents for Smeg TRA90GMP
- Page 1 TRA90GMBL INSTRUCTION MANUAL FREE-STANDING COOKER TRA90GMP...
- Page 2 WARNING: READ THIS INSTRUCTION MANUAL BEFORE USING THE APPLIANCE...
-
Page 3: Table Of Contents
Preliminary operations Instructions for the installer We advise you to read this manual carefully, which contains all the instructions for maintaining the appliance’s aesthetic and functional qualities. For further information on the product: www.smeg.com PRECAUTIONS General safety instructions • This appliance may only be... - Page 4 they are constantly supervised. lid or a blanket. • Keep children under the age of • The appliance becomes very 8 away from the appliance hot during use. Take care never when it is in use. to touch the heating elements •...
- Page 5 AVAILABLE) OR NEAR THE damaged, contact technical APPLIANCE. support immediately to arrange • DO NOT USE AEROSOLS IN for it to be replaced in order to THE VICINITY OF THIS avoid possible hazards. APPLIANCE WHILST IT IS IN • WARNING: A gas cooking USE.
- Page 6 into the side guides. The bottom as a support for mechanical safety locks that cooking. prevent them from being • If you wish to use greaseproof removed must face downwards paper, place it so that it will not and towards the back of the interfere with the hot air oven.
-
Page 7: Installation
• Never use the oven door to ventilation. lever the appliance into place • The settings for this appliance when fitting. are shown on the gas setting • Avoid exerting too much label. pressure on the door when • Have the gas connection open. -
Page 8: Appliance Purpose
• Use cables that can withstand • use of the appliance other than that specified; temperatures of at least 90°C. • failure to comply with the instructions in the • The tightening torque of the user manual; screws of the terminal supply •... -
Page 9: To Save Energy
information sheet" that can be downloaded Information/Advice from the website at the page dedicated to the product in question. To save energy • Only preheat the appliance if the recipe requires you to do so. • Unless otherwise indicated on the package, defrost frozen foods before placing them in the oven. -
Page 10: Description
DESCRIPTION General description 1 Hob 5 Door 2 Control panel 6 Storage compartment 3 Oven light 7 Fans 4 Seal Frame shelf AUX = Auxiliary Burner SR = Semi-rapid Burner R = Rapid Burner UR2 int. = Ultra rapid internal burner UR2 ext. -
Page 11: Control Panel
Control panel 1 Function knob the appliance and which may continue for a brief period of time even after the appliance has The oven’s various functions are suitable for been turned off. different cooking modes. After selecting the required function, set the cooking temperature Do not obstruct ventilation openings using the temperature knob. -
Page 12: Use
Oven tray Tray rack Useful for collecting fat from foods placed on Useful for supporting containers with food the rack above and for cooking pies, pizzas, during cooking. baked desserts, biscuits, etc. Rack Deep tray To be placed over the top of the oven tray; for Useful for collecting fat from foods placed on cooking foods which may drip. -
Page 13: Using The Hob
rack from being removed accidentally must Keep the knob pressed in longer. face downwards and towards the back of In case of an accidental switching off, a the oven cavity. safety device will be tripped, cutting off the gas supply, even if the gas cock is open. -
Page 14: Using The Oven
necessary when using the appliance. FAN WITH GRILL Allows optimal grilling, even for thick Using the oven slices of meat. Perfect for larger cuts of meat. See General safety instructions. FAN ASSISTED Intense and uniform cooking. Ideal for Switching on the oven biscuits, cakes and cooking on more To switch on the oven: than one level. -
Page 15: Digital Programmer
Digital programmer Timed cooking Timed cooking is the function which allows a cooking operation to be started and then ended after a specific length of time set by the user. 1. After selecting a cooking function and temperature, press the button. -
Page 16: Cooking Advice
Setting the volume of the buzzer activate. The current time and the The buzzer can have 3 tones. symbol appear on the display. 5. At the end of cooking the heating elements When the buzzer is in operation, press the will be deactivated. -
Page 17: Cooking Information Table
Advice for cooking on two shelves: and CIRCULAIRE+BOTTOM. • We recommend using two racks (they can Advice for defrosting and proving be obtained from Authorised Assistance • Place frozen foods without their packaging Centres). in a lidless container on the first shelf of the •... -
Page 18: Cleaning And Maintenance
Weight Temp. Time Food Function Shelf (Kg) (°C) (minutes) Turbot TURBO/CIRCULAIRE 45 - 50 Pizza TURBO/CIRCULAIRE 8 - 9 Bread CIRCULAIRE 190 - 200 25 - 30 Focaccia TURBO/CIRCULAIRE 180 - 190 20 - 25 Bundt cake CIRCULAIRE 55 - 60 Tart CIRCULAIRE 35 - 40... -
Page 19: Knobs
Flame-spreader crown and burner caps 1. Open the door completely and insert two pins into the holes on the hinges indicated in For easier cleaning, the flame-spreader crowns the figure. and the burner caps can be removed. Wash them in hot water and non-abrasive detergent. Carefully remove any encrustation, then wait until they are perfectly dry. -
Page 20: Cleaning The Oven Cavity
internal pane of glass from the front (2) to 6. When you have finished cleaning, reinsert remove it from the door. the intermediate glass pane in its housing in the door. 4. Remove the intermediate glass pane by lifting it upwards. 7. -
Page 21: Vapor Clean (On Some Models Only)
Vapor Clean (on some models only) that uses heat to remove light grease residues. It does not remove sugar-based residues. 1. First clean the base and the top of the oven See General safety instructions. cavity using a microfibre cloth soaked in water and neutral washing up liquid. -
Page 22: Extraordinary Maintenance
3. Use a non-scratch sponge with brass Take care not to scratch the enamel of filaments on hard to remove deposits. the oven cavity wall. 4. In case of grease residues use specific oven cleaning products. 4. Slide out and remove the light bulb. 5. -
Page 23: Installation
INSTALLATION authorised person in accordance with this The appliance must be installed by a instruction manual, AS/NZS 5601.1 – Gas qualified technician and according to installations (installation and pipe sizing), local the regulations in force. gas fitting regulations, local electrical regulations, local health regulations, Building Code of Australia and any other government Appliance factory set for gas: NG... - Page 24 Replacing nozzles the LPG cylinder regulator(s) as appropriate in accordance with AS/NZS 5601. Patent 2015101170. For enquires contact Gas Approval Consulting Pty Ltd Smeg licence 037 for GSCS20265 Connection to LPG A = External nozzle, B = Internal nozzle. 1. Remove the pan supports, burner caps and...
-
Page 25: Burner And Nozzle Characteristics Tables
town gas stable. Turn the knob rapidly from the maximum to the minimum setting: The flame should not go out. Repeat the operation on all gas cocks. Adjusting the minimum setting for LPG Tighten the screw located at the side of the cock spindle clockwise all the way. - Page 26 Appliance dimensions The supply connection point must be accessible with the appliance installed. If a hood is installed above the appliance, refer to the hood instructions manual to make sure the correct clearance is left. Appliance overall dimensions Position of electrical connection Levelling the appliance See General safety instructions.
- Page 27 Assembling the upstand 3. Assemble the fastening bracket. 4. Align the base of the hook on the fastening bracket with the base of the slot on the wall The upstand must always be positioned and fastening plate. secured correctly on the appliance. 1.
- Page 28 7. Move the bracket onto the wall and mark 2. Attach the chain to the cooker using the the position of the holes to be drilled in the screw that was removed in the previous wall. step. 8. After drilling the holes in the wall, use wall plugs and screws to fasten the bracket to the 3.
-
Page 29: Electrical Connection
Electrical connection 1. Remove the screws fastening the plate to the rear casing See General safety instructions. General information Check the mains characteristics against the data indicated on the plate. The identification plate bearing the technical data, serial number and brand name is visibly positioned on the appliance. -
Page 30: Instructions For The Installer
Instructions for the installer • If you use a plug to connect to the power supply, the plug must be accessible after installation. • Do not bend or trap the power cable. • The appliance must be installed according to the installation diagrams. •... - Page 31 The manufacturer reserves the right to make any changes deemed useful for improvement of its products without prior notice. The illustrations and descriptions contained in this manual are therefore not binding and are merely indicative.
- Page 32 Space for rating plate SMEG S.p.A. Via Leonardo Da Vinci, 4 42016 San Girolamo di Guastalla (RE) ITALY A240227 www.smeg.com 91477B263/A...
Need help?
Do you have a question about the TRA90GMP and is the answer not in the manual?
Questions and answers