Table of Contents
Advertisement
Mixer Function
Editing DSP Channel Parameters
1.
While Channel 16 is selected, press the [
CURSOR button.
• This selects the DSP channel.
• Pressing the [
] CURSOR button while the DSP
channel is selected returns to Channel 16.
How Parameters Work
The following are the parameters whose settings can be
changed in the Parameter Edit Mode.
Tone Parameters
Tone (Range: 000 to 903, Drawbar organ tones 000 to 199)
This parameter controls the tones assigned to each part.
Anytime the tone is on the display, you can use the TONE
button or DRAWBAR ORGAN button and then select a
different tone, if you want.
S
. t
Part On/Off (Settings: on, oFF)
This parameter can be used to turn each part on (sounds) and
off (does not sound). The current on/off status of each part is
indicated on the display as described below.
C
a h
Volume (Range: 000 to 127)
This is the parameter that controls the volume of the selected
channel.
V
l o
Pan Pot (Range: –64 to 00 to +63)
This parameter controls the pan pot, which is the center point
of the left and right stereo channels. Setting "00" specifies
center, a value less than "00" moves the point left, and a value
greater than "00" moves it right.
P n a
E-38
]
G P n o
r
n e l
n
u e
m
Octave Shift (Range: –2 to 0 to +2)
You can use octave shift to shift the range of the tone up or
down. When using the piccolo tone, there may be cases when
very high notes you want to play are not included within the
range of the keyboard. When this happens, you can use
octave shift to shift the keyboard range one octave up.
O
t c
–2 :Range shifted two octaves down.
–1 :Range shifted one octave down.
0 :No shift
+1 :Range shifted one octave up.
+2 :Range shifted two octaves up.
Tuning Parameters
You can use these parameters to tune each of the parts
individually.
Coarse Tune (Range: –24 to 00 to +24)
This parameter controls the coarse tuning of the selected
channel's pitch in semitone units.
C
T .
Fine Tune (Range: –99 to 00 to +99)
This parameter controls the fine tuning of the selected
channel's pitch in cent units.
F
n i
Effect Parameters
The Mixer lets you control the effects applied to each
individual part, making it different from the Effect Mode,
whose settings are applied to all parts in general.
Reverb Send (Range: 000 to 127)
This parameter controls how much reverb is applied to a part.
A setting of "000" turns reverb off, while a setting of 127
applies maximum reverb.
• "Reverb Send" does not work with some drum sounds.
R
b v
S i f t
h
u e n
e u n e
T
S
e n d
707A-E-040A
Advertisement
Table of Contents
