Table of Contents
Advertisement
Returning the keyboard to its initial factory defaults
The "Data" folder on the CD-ROM that comes bundled with
the keyboard includes a file named "alldata.ckf", which
contains factory default setup data. Transferring the
"alldata.ckf" data to the keyboard's flash memory will return
all settings to their initial factory defaults.
• For information about transferring data to the keyboard's
flash memory, see the application software manual.
To connect to a computer
Be sure to turn off the keyboard and your computer before
connecting them. You should also set the volume controller of
the keyboard to a relatively low volume.
1.
Connect the keyboard's MIDI interface to your
computer's MIDI interface.
CTK-900
2.
Turn on the keyboard, and then turn on your
computer or other connected device.
3.
Start up the software you want to use on your
computer.
707A-E-079A
• When using the application software, make sure that the
tone setting screen (the screen that appears after turning on
power) is on the keyboard's display screen.
• Performing a keyboard operation while transferring data
between it and a computer may interrupt the data transfer.
Do not perform any keyboard operations while data transfer
is in progress.
DATA ACCESS Lamp
• The DATA ACCESS lamp lights whenever the keyboard is
exchanging data with a connected computer over a MIDI
cable connection. Never disconnect the MIDI cable while
the DATA ACCESS lamp is lit.
MIDI
E-77
Advertisement
Table of Contents
