DETECT COUNTER
The detect counter is used to indicate the number of times metal has been
detected since the counter was last reset. Reset the counter during
product changeover for more accurate product run information. To reset the
counter, use Menu 10.
PASSWORD PROTECTION
The Series 1200E is dual password protected to avoid unauthorized
tampering. A low level password is required to move beyond the "Run" menu
(#7) and a high level password is needed to access the performance
validation feature or the product options and detector settings. All
detectors are shipped from the factory with both passwords set at " 1234.
" To install a custom password, use Menus 25-26 or Menus 74-75. NOTE: Once
a password has been entered, access is granted for 20 minutes and the
password need not be entered again until the time expires.
PRODUCT CHANGEOVER
Product changeover is a simple matter. If the settings for the new product
have already been learned, use Menus 10-11 to select that product. If the
settings have not been stored, use the setup procedures earlier in this
manual.
RESTORE DEFAULTS
Menu 76 can be used to reset the entire metal detector memory to the
factory settings, CAUTION should be used with this feature as it will
reset all product settings, reject timing settings, etc., and all stored
settings will be lost.
The password will be restored to the default
setting of 1200.
18
Need help?
Do you have a question about the 1200E Series and is the answer not in the manual?