Set-Up Of Difficult Products - Advanced Detection Systems 1200E Series Installation Manual And Owner's Manual

SET-UP FOR DIFFICULT PRODUCTS
If no phase setting can be found which allows the product to pass through
the unit undetected, change the wet/dry indicator to the wet position (use
Menus 52 and 53). Return to Step 3 of "Manual Adjust".
If a phase setting still cannot be found, set the wet/dry indicator to dry
and the field strength to low. Use Menus 52 and 53 and Menus 49 and 51.
Try Step 3 again.
Finally, if a phase setting still cannot be found, set the wet/dry
indicator to wet and the field strength to low. Return to Step 3.
If you are still unable to find a phase setting that allows the product to
pass undetected, see the pages on "Mechanical" and "Electrical
Installation" and review them for possible problems. If no solution can be
found, consult the factory.
13