Table of Contents
Advertisement
DSL-15D1T
PAL(‡»
˙ )GB
03.11.27 5:24 PM
Installation
Manual setup
Call up Manual Setup from the Setup menu.
PROGRAMME NUMBER SELECTION
1. Position a selection bar to PR.
2. Press the LEFT/RIGHT buttons to select a programme
number you want.
TV SYSTEM SELECTION
If necessary, you can change the TV System.
1. Position a selection bar to System.
2. Select the TV system with LEFT/RIGHT button.
BG : West and North Europe, Australia, N/Zealand,
Middle-East, Asia, Africa
DK : East Europe, CIS, China, Vietnam
I
: Great Britain, Ireland, Hong Kong,S/Africa
L : France, Switzerland
NOTE : The L is displayed only when you had selected
the Country "F"or "CH" in Auto setup.
CHANNEL SEARCH
Up/Down Search
1. Position the selection bar to Search.
2. Press the RIGHT or LEFT button to search up or down.
Searching will stop at the next channel found and then
the channel will be stored automatically.
Direct Search
You can directly locate a program by entering the
channel number.
1. Position the selection bar to CH.
2. Select a channel with LEFT/RIGHT button.
The selected channel will be stored automatically.
14
˘
` 14
mac001
1200DPI 80LPI
Picture
Manual setup
Sound
PR
Features
CH
Setup
Name
RTL-2
System
Colour
Search
Fine tune
Select
Adjust
Search
C10
PR12
Please wait!
Search
Exit
FINE TUNING
If you are unable to get a good picture or sound because
of a poor broadcast signal, it is possible to adjust the fine
tuning.
1. Move the selection bar to Fine tune.
2. Press the RIGHT or LEFT button to activate fine tuning
4
up or down.
C 5
It operates while the RIGHT/LEFT button is being
BG
pressed.
PAL
The change is stored automatically.
Exit
ENTER A STATION NAME
You can change an existing name, or enter a name
where none exists.
1. Move the selection bar to Name.
2. Press the RIGHT buttons to call up the Name menu.
3. Select the position with UP/DOWN button.
4. Use the LEFT/RIGHT buttons to select the desired
character :
A B C ... Z + - . (blank) 1 2 ... 9
COLOUR STANDARD SELECTION
If necessary, you can change the Colour standard.
1. Position a selection bar to Colour.
2. Use the LEFT/RIGHT buttons to select the desired
Colour standard : PAL
NOTE : In the AV mode
PAL
SECAM
Installation
F i n e T u n e
-
Picture
Name
Sound
Name
Features
1
Setup
2
3
4
5
Select
SECAM
AUTOM
0
+
Adjust
R T L - 2
R
T
L
-
2
Adjust
Exit
15
Advertisement
Table of Contents
