Marking And Searhing - Aiwa XR-DV3M Operating Instructions Manual

MARKING AND SEARCHING
You can mark any point in a disc and start play from there.
Using search functions, you can easily locate a desired point on a
disc.
c
MARKING
You can mark up to 5 DVDs, each with up to 5 points.
Also, you can mark up to a total of 10 audio CDs and video CDs,
each with up to 5 points.
1 Play the disc and locate the desired point to mark.
You can use functions such as "FAST FORWARD/REWIND",
"SKIPPING" or "SEARCH" to locate your desired point.
2 Press MARK.
" " appears on the monitor screen and the unit enters the Mark
mode. The current Mark memory number is highlighted by the
cursor.
* * * * *
3 Press ENTER or c.
The current location is marked in the Mark memory.
1
* * *
4 Press MARK again to exit the Mark mode.
To mark other points
1 Follow steps 1 and 2 of "MARKING" above.
2 Press j or l to move the cursor, or press a correspording
number button (1-5), to select the desired Mark memory position
( ).
*
3 Follow steps 3 and 4 of "MARKING" above.
NOTE
If the title search, chapter search or time search function is used
to locate the desired point, " " clears. If this happens, press MARK
to call up " ". (For DVDs, " " also clears when the skip function is
used.)
28
ENGLISH
To play from a marked point
1 Press MARK.
" " appears on the monitor screen and the unit enters the Mark
mode.
2 Press j or l to move the cursor, or press a corresponding
number button (1 - 5), to select the desired Mark memory
number.
T-SEARCH
3 Press ENTER or c.
Play starts from the marked point.
MARK
0-9,+10
NOTE
C
When play is started from a marked point, the "Audio Language"
i/k/j/l
and "Subtitle Language" are set to the ones selected when the
ENTER
point was marked.
c/d
To clear a marked point
1 Press MARK.
" " appears on the monitor screen and the unit enters the Mark
mode.
2 Press j or l to move the cursor or press a corresponding
number button (1 - 5) to select the desired Mark memory
number.
3 Press C.
The Mark memory is cleared.
TITLE SEARCH (DVD ONLY)
You can specify the playing location of a DVD by the title number.
1 Press T-SEARCH.
2 Press the numbered buttons to enter the desired
title number.
Example:
To play title number 2, press 2.
To play title number 10, press +10.
You can also use i or k to change the selected track number
on the monitor screen.
If you entered a wrong number
Press C to remove the number you entered. Then enter the
correct number.
3 Press ENTER or c.
Play begins at the specified title.
NOTE
If you specify a title number which does not exist on the disc, the
symbol is displayed. In this case, repeat from step 1 with a
valid title number.
T 1
T 2