LUCCI PANTON 27043101 Installation Instructions Manual

Installation Instructions
To ensure correct function and safety, please read and follow all instructions carefully before using the product. Please
keep instructions for future reference.
Warranty
•
This portable luminaire is covered by a 12-month warranty from the date of purchase. Please retain the proof of
purchase.
•
Warranty will be void if there is any damage due to improper usage or modification to the portable luminaire.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the
warranty.
Installation requirements
This product conforms to UL standard 153 and CSA STD. C22.2 NO.250.4.
•
Select a suitable location for this portable luminaire:
- Ensure it is on a flat and stable surface.
- This portable luminaire is suitable for indoor use only.
- Do not place flammable material near or over the portable luminaire.
- Ensure the portable luminaire is not installed in direct line of an air vent/system.
- If the portable luminaire is placed in an area prone to moisture, ensure that the area is well ventilated, and an
appropriately rated exhaust fan is used if required. Damage or corrosion caused by moisture is not a product fault,
and as such is not covered under warranty.
•
Do not exceed the maximum wattage rating：
G9: Max.25W XENON bulb or Max. 5W G9 LED bulb
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure no components are missing before assembling. If
parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
•
Do not plug into the mains power socket-outlet before or during assembly. Only do so after the portable luminaire is
fully assembled with the globe installed and is ready to use for the first time.
Installation directions
1. Remove all packaging material from the product.
2. Open the lamp base (F), be loosening the 3 screws (G) at the bottom of the portable luminaire by screwdriver (H,
not included).
3. Carefully push and feed the cord through the hole in the shade (A) to lower the lamp base (F) and access the lamp
holder (E).
4. Install a bulb (D - not included) into the lamp holder (E). Do not exceed the maximum wattage rating.
NOTE: G9: Max.25W XENON bulb or Max. 5W G9 LED bulb
NOTE: If using a XENON bulb, do not touch with your bare hands, use clean gloves or a tissue.
Using bare hands may reduce the life of the XENON bulb.
1 | P a g e
For customer support, please contact:
Tel: +1 (949) 800 8488
PANTON 1 LIGHT TABLE LAMP
SKU# 27043101
Rated Voltage 120V~ 60Hz
Email: support@beaconlighting.us www.beaconlighting.us
V 1 . 0 0 7 . 2 0 2 3