LUCCI OSBORNE DAY NIGHT SLEEP PLUS Installation Instructions

Installation Instructions
To ensure correct function and safety, please read and follow all instructions carefully before assembly, installation and use
of this luminaire. Please keep the instructions for future reference.

Warranty

•
This portable luminaire is covered by a 3-year warranty valid for in-store replacement or refund only.
•
The warranty period starts from the date of purchase. Please retain the proof of purchase.
•
The warranty will be void, if there is any damage due to improper usage or modification to the portable luminaire.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the
warranty.

Installation Requirements

•
Select a suitable location for this portable luminaire:
Ensure it is on a flat and stable surface.
-
This portable luminaire is suitable for indoor use only.
-
Do not place flammable material near or over the portable luminaire.
-
Ensure the portable luminaire is not installed in direct line of an air vent/system.
-
If the portable luminaire is placed in an area prone to moisture, ensure that the area is well ventilated, and an
-
appropriately rated exhaust fan is used if required. Damage or corrosion caused by moisture is not a product
fault, and as such is not covered under warranty.
•
Only use the supplied plug in LED driver with this luminaire.
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure there are no components missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate/install any luminaire which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
•
Do not plug into the mains power socket outlet before or during assembly. Only do so after the luminaire is fully
assembled and is ready to use for the first time.

Installation Directions

1. Remove all packaging material from the portable luminaire.
2. Install the top section of the luminaire (B) onto the middle section (E) and secure by tightening the grub screw with
the allen key (C) provided. Install the middle section (E) of the luminaire into the bottom section (F).
NOTE: Take care not to cross-thread or twist and damage the cord during assembly. Pull the cord out from the
back of the bottom section (F) as you assemble. Check the cord after every three turns when installing
the top part of the luminaire (B) onto the middle section (E) and bottom section (F). Relieve any twist in
the cord by turning it anti-clockwise.
3. Attach the lamp base (G) onto bottom section of the luminaire (F), and secure by installing the star washer, spring
washer and nut with the spanner (H) provided.
4. Adjust the luminaire head (A) to your desired angle.
NOTE: Do not adjust luminaire head (A) more than the 330° as this may damage the joint and internal wires.
5. To adjust the height of the luminaire, loosen the grub screw and the telescopic tube clamp lock (D). Pull the cord out
or push the cord in at the cord entry point at the back of the bottom section (F) during the height adjustment. After
adjusting to your desired height, tighten the telescopic tube clamp lock (D) and the grub screw to ensure it is secure.
1 | P a g e
OSBORNE DAY NIGHT SLEEP PLUS LED FLOOR LAMP
Rated Voltage 220-240V~ 50Hz
SKU# 269780, 269781
v 1 . 0 ( 0 6 / 2 0 2 3 )