LUCCI NEVADA Installation Instructions

Installation Instructions
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep the instructions for future reference.

Warranty


This luminaire is covered by a 12 month warranty from the date of purchase. Please retain proof of purchase.

Warranty will be void if there is any damage due to improper usage or modification to the luminaire.

Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.

Installation Requirements


Select a suitable location for this luminaire:
- Ensure it is on a flat and stable surface.
- This luminaire is suitable for indoor use only.
- Do not place flammable material near or over the luminaire.
- Ensure the luminaire is not installed in direct line of an air vent/system.
- If the luminaire is placed in an area prone to moisture, ensure that the area is well ventilated and an appropriately
rated exhaust fan is used if required. Damage or corrosion caused by moisture is not a product fault, and as such
is not covered under warranty.

Do not exceed the maximum wattage rating.

Take care not to pull any electrical wires during unpacking as this may damage the connection.

Lay out all the components on a smooth surface and make sure there are no components missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.

Check whether the luminaire has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.

Do not plug into the mains power socket outlet before or during assembly. Only do so after the luminaire is fully
assembled with the globe installed and is ready to use for the first time.

Installation Directions

1. Remove all packaging material from the product and be careful not to throw away accessories that may be hidden
within the packaging material. If assembly is required, place the luminaire on a smooth non-scratch surface.
2. Install the upper rod (D) onto the lower rod (E). Pull the cord out from the lower rod (E) as you assemble to remove
any slack in the cord. Take care not to damage the cord during assembly or cross thread.
3. Install the rod (E) onto the lamp base (G) and secure by tightening the hex screw (H) with the Allen key provided (I).
4. Remove the lamp shade (A) by loosening the hex screw (C) with the Allen key provided (B).
5. Install globes (J - not included) into the lamp holders (K). LED globe only. Do not exceed the maximum rated wattage.
6. Install the lamp shade (A) back onto the luminaire and secure by tightening the hex screw (C).
7. Select a suitable location for the portable luminaire. See the installation requirements above.
8. Insert the plug (F) into the mains power socket outlet and ensure it is fully plugged in.
9. Turn power on at the mains power socket outlet.
10. Use the switch (L) to turn the luminaire on/off.
1 | P a g e
NEVADA 3 LIGHT FLOOR LAMP
SKU# 261474, 261475
Rated Voltage 220-240V~ 50Hz
v 1 . 0 ( 0 4 / 2 0 1 9 )