LUCCI LUNA Installation Instructions

Installation Instructions
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of the product. Please keep the instructions for future reference.

Warranty

•
This product is covered by a 1 year warranty. Please retain proof of purchase.
•
Warranty will be void if there is any damage due to improper usage or modification to the product.
•
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.

Installation requirements

•
Select a suitable location for the luminaire;
- Ensure it is on a flat and stable surface.
- This product is suitable for indoor use only.
- Do not place flammable material near or over the luminaire.
- Ensure the luminaire is not installed next to any air vents and is not in any moist or damp areas.
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure there are no components missing before
assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
•
Check whether the luminaire has been damaged during transport. Do not operate/install any product which
appears damaged in any way. Return the complete product to the place of purchase for inspection, repair or
replacement.

Operation directions

Operation:
1. Press the power switch (1) or (7) for one second to switch on the luminaire.
2. Carry the luminaire to your desired location by pulling out the handle (2) on the top of the luminaire.
3. Adjust the light output from minimum to maximum by touching the brightness control dots (3) or (6).
4. When turned on, light will be cool white. Colour temperature can be changed between cool white and warm white
when the luminaire is rotated 180° .
The colour temperature will adjust gradually according to the tilted angles. When the luminaire is rotated 90° and
left in horizontal positon, the light will be half cool white and half warm white.
NOTE: The power switches (1) or (7) and brightness control dots (3) or (6) will be deactivated when it is tilted at 45° .
5. Press the power switch (1) or (7) for one second again, the luminaire will turn off.

Batteries and charging:

1. When the charging indicator (8) is blue & flashing, the batteries is low and will run out in 10 – 20 minutes.
Plug the provided USB cable in the charging port (5) and connect the USB cable to computer/laptop or power
adaptor to charge the luminaire. The charging indicator will be red when charging and will be off when fully
charged. (Time to fully charge is approximately 5 – 6 hours).
NOTE: Please ensure an appropriate power adaptor is used for charging according to the rated input (5V DC, 600mA)
of this luminaire.
1 | P a g e
LUNA REVERSIBLE COLOUR CHANGING LAMP
Rated Voltage 5V DC, 600mA
SKU# 269396
v 1 . 0 ( 0 8 / 2 0 1 8 )