Motorola IDEN WIRELESS DATA SERVICES User Manual page 77

Configuring Port and Dial Settings
If you are installing data-enabled phone on a computer or hand-held device
that does not use Microsoft
®
Windows 2000, or Windows
follows:
Baud rate=19200
Data bits=8
Stop bits=1
Parity=None
Duplex=Full
Dial Method=Tone
Flow Control=Hardware
Data Initialization String=AT&K3
If the hardware flow control is not supported, set the Data Initialization
String to AT&K4.
Configuring the Modem with AT Commands
If you are not using the Installation disk, configure your
AT command set using the following guidelines.
Enter the command indicated next to Command Syntax.
DCE refers to the modem on your iDEN phone.
DTE refers to your computer or hand-held computing
device.
Restore Factory Defaults
First, restore the current values to their factory default values. This will
ensure a clean start for the rest of the configuration.
AT Command
Command Syntax
Expected Return Code(s)
® Windows ® 95, Windows
®
ME, configure your port and dial settings, as
N O T E
Restore Factory-Default Configuration
AT&F
OK
Appendix
® 98, Windows ® NT,
73