When the water tank is full, the unit stops automatically. The TANK FULL light illuminates on the control
panel.
NOTE: Only empty the water tank when it is full or before moving, turning off or storing the unit.
There are two ways to dispense collected water.
1. USE THE TANK
When the tank is full, the unit automatically stops running, and
the Tank Full indicator flashes.
Slowly pull out the tank. Securely grip the tank by its handle
and carefully pull it out. Empty the water tank and reinsert it
into the dehumidifier. The tank must be in place and securely
seated for the dehumidifier to operate again. The dehumidifier
will restart when the tank is restored to its correct position.
NOTES:
When you remove the water tank, please do not touch the
sensors or any parts behind it. Doing so may damage the
product. Be sure to push the tank gently all the way into the
unit. Banging the bucket against anything or failing to push it
in securely may cause the unit not to operate.
Do not remove any parts from the water tank or tank
enclosure. The full water sensor will no longer be able to
detect the water level correctly, and water may leak from the
water tank.
2. CONTINUOUS DRAINAGE (PIPE NOT SUPPLIED)
Water can be automatically plumbed in or drained into a sink, a larger container, or through the wall into an
outside drain by attaching a pipe (10 mm internal diameter and up to 1 metre in length) to the unit. Insert
the pipe into the drain outlet at the back of the unit, as shown here.
Make sure the connection between the pipe and the drain outlet is tight and does not leak. Then, direct the
pipe to a suitable drainage point. This unit uses gravity to dispose of water, so the drain should be lower
than the water outlet on the unit. Put the tank back. Be sure to run the water pipe downward and let the
water flow out smoothly. Do not kink or bend the pipe.
The permanent drain can be used in conjunction with a water pump (e.g. when draining from a cellar) to lift
the water upwards.
WATER DRAINAGE
14
Need help?
Do you have a question about the CD12PRO-LE-V4 and is the answer not in the manual?