Other Safety Considerations; Special Instructions - Morphy Richards TURBO Steam Quick Start Manual

caution when you turn a steam iron upside
down, there may be hot water in the water
tank.
WARNING: To protect against the risk of
electric shock, do not put the appliance in
water or in any other liquid.
Do not use the vertical steam feature on
clothes that are being worn.
Do not leave the iron unattended whilst
plugged in or on an ironing board.
Never allow the mains lead to over hang
the work surface.
The socket should always be off before
plugging or unplugging from the socket.
Never yank the cord to disconnect from
the socket, instead, grasp the plug and
pull to disconnect.
Do not allow the cord to touch hot
surfaces.
Let the iron cool completely before putting
away. Loop the cord loosely around the
iron before storing.
The iron must not be left unattended while
it is connected to the supply mains.

Other safety considerations

Use the iron only for its intended use.
Always disconnect the iron from the
electrical socket when filling with water or
emptying, and when not in use.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified person(s) in
order to avoid a hazard.
Do not operate the iron with a damaged
cord, or if the iron has been dropped or
damaged and if there are visible signs of
damage, or if it is leaking. To avoid the risk
of electric shock, do not disassemble the
iron, but telephone Morphy Richards for
advice. Incorrect reassembly can cause a
risk of electric shock when the iron is
used.

Special instructions

If your iron does not work, check the
following points:
Has the temperature control been set to
the required temperature? Is the plug in its
socket? Is the plug itself or the socket
faulty? (Check by plugging in another
appliance).
WARNING:
When not in use, your iron
should never be placed flat and left on an
ironing board.
To prevent damage to the textile being
ironed, follow the temperature guide
carefully. (Test the inside of the hem of the
garment).
When ironing is complete, remove the
plug from the socket, empty any
remaining water from the tank, and allow
to cool before storage.
If you drop or severely knock your iron,
this could cause internal damage even if
the outside appears alright. Have it
checked by a qualified electrician.
It is recommended that you use up one
beaker of water by operating your iron's
steam and steam boost functions before
ironing any clothes as some dripping may
occur while your iron's steam system is
activated.
6