Features Of Your Iron - Morphy Richards TURBO Steam Quick Start Manual

immediately. If you wait a few minutes, the iron
will stabilise at the required setting.
Your Morphy Richards iron is fitted with a
temperature indicator light 9 which will go on
and off while you are ironing. This is perfectly
normal as it shows that the iron is maintaining
the heat setting you have chosen.
It is always a good idea to begin with 'cool'
fabrics and work up to higher settings. An iron
heats up quicker than it cools down so you'll
save time and electricity.

Features Of Your Iron

Temperature indicator light
The indicator light shows that the iron is
warming up. When the required temperature
is reached, the light will go out and will cycle
on-off during operation.
Dry ironing
You can use your iron as a dry iron only. Make
sure the variable steam control 3 is set to the
'0' symbol.
Any temperature setting may be used
depending on the garment. The spray feature
may be used provided there is water in the
tank (see 'Filling' section). You do not need to
put any water in the tank when dry ironing
only.
Spray "C"
Press the spray button 2 and aim the spray of
water at stubborn creases. You can do this
whilst dry ironing, providing there is water in
the tank. When using the water spray, it may
be necessary to push the button a few times
to get the spray pump primed.
Variable steam
Fill the iron with water as described in 'Filling'
"A", and insert the plug into the electrical
socket.
The steam output can be varied from low to
high by rotating the variable steam control
"D".
The steam facility should only be used on
garments which are suitable for ironing at 2
and 3 dot settings.
Shot of steam E
(certain models only)
Press the shot of steam button 1 to obtain a
burst of extra steam for ironing out creases in
heavy material such as denim etc.
The shot of steam can be used whilst dry
ironing, providing there is water in the tank,
and the temperature control is set within the
steam range.
Do not use shot of steam at temperatures
below the steam range shown on the control.
Note: For optimum steam quality, do not
operate the shot more than three times in
succession.
Vertical steam
(certain models only)
Hold the iron in a vertical position between
1cm and 2cm away from the item "F". Press
the shot of steam button 1, this will create
vertical steam. This feature is especially
useful for removing creases from hanging
clothes, curtains, wall hangings, etc.
Note:
For optimum steam quality, do not
operate the shot more than three times in
succession.
No drip system
Your iron is fitted with a no
drip system which is
designed to prevent water
e s c a p i n g f r o m t h e
soleplate when the iron is
too cold.
During use, the no drip
system may emit a loud
4