Maintenance; Important Safety Instructions; Other Safety Considerations - Morphy Richards COMFIGRIP Trizone Quick Start Manual

horizontal position for 1 minute, or the vertical
p o s i t i o n f o r 8
minutes.
The auto shut-off
indicator (5) will
f l a s h a n d a n
intermittent beep
will be audible. Gently shake the iron to
reactivate. The temperature indicator light (9)
will come on. Wait for the iron to heat-up and
continue ironing.

Maintenance

To clean a coated soleplate Do not use
scouring powder or solution as this could
cause damage to the coating. In the unlikely
event of any man-made fibre fusing to the
soleplate, set the iron at the MAX position and
pass it over a clean piece of cotton which will
draw the deposit off the surface. IMPORTANT:
Do not descale the soleplate with descaling
products, proprietary cleaning agents or
vinegar when flushing out the soleplate. To
clean the exterior Allow the iron to cool and
wipe over with a damp cloth and mild
detergent, then wipe with a dry cloth.

Important Safety Instructions

Location
Do not use outdoors or near water.
Children
Close supervision is necessary when any
appliance is used near children.
Children do not understand the dangers
associated with operating electrical
appliances.
Personal safety
WARNING: Burns can occur from touching
hot metal parts, hot water or steam. Use
5
9
caution when you turn a steam iron upside
down, there may be hot water in the water
tank.
WARNING: To protect against the risk of
electric shock, do not put the appliance in
water or in any other liquid.
Do not use the vertical steam feature on
clothes that are being worn.
Do not leave the iron unattended whilst
plugged in or on an ironing board.
Never allow the mains lead to over hang
the work surface.
The socket should always be off before
plugging or unplugging from the socket.
Never yank the cord to disconnect from
the socket, instead, grasp the plug and
pull to disconnect.
Do not allow the cord to touch hot
surfaces.
Let the iron cool completely before putting
away. Loop the cord loosely around the
iron before storing.
The iron must not be left unattended while
it is connected to the supply mains.

Other safety considerations

Use the iron only for its intended use.
Always disconnect the iron from the
electrical socket when filling with water or
emptying, and when not in use.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified person(s) in
order to avoid a hazard.
Do not operate the iron with a damaged
cord, or if the iron has been dropped or
damaged and if there are visible signs of
damage, or if it is leaking. To avoid the risk