Other Safety Considerations; Electrical Requirements; Special Instructions - Morphy Richards JETSTREAM Instruction Manual

42370MCZ-Rev1-SteamGenerator
• The steam generator must be used
and rested on a stable surface; –
• When placing the iron on its base
unit, ensure that the surface on
which the base unit is placed is
stable;
• The iron is not to be used if it has
been dropped, if there are visible
signs of damage or if it is leaking

Other safety considerations

• Use the steam generator only for its
intended use.
• Never hold the generator base under
a tap.
• Always disconnect the steam
generator from the electrical supply
when cleaning or when not in use.
• Do not operate the steam generator
with a damaged cord or if the iron has
been dropped or damaged. To avoid
the risk of electric shock, do not
disassemble the product, but
telephone Morphy Richards for
advice. Incorrect reassembly can
cause a risk of electric shock when
the steam generator is used.
• If the need arises to change the mains
cable on your steam generator or the
iron, please return to Morphy
Richards service department at the
address on the back page.

Special instructions

• If your steam generator does not
work, check the following points:
Has the temperature control been set
to the required temperature? Is the
plug in its socket? Is the plug itself or
the socket faulty? (Check by plugging
in another appliance).
• Is the dry/steam selection switch on
the base unit set to dry.
• To prevent damage to the textile
being ironed, follow the temperature
guide carefully. (Test the inside of the
hem of the garment).
• When ironing is complete, remove the
plug from the socket, and allow the
unit to cool before storage.
25/9/06 4:39 pm Page 3
• WARNING The boiler may still be
pressurised and no attempt
should be made to remove the
boiler cap. Steam will escape and
you could get burnt.
• If you drop or severely knock your
steam generator this could cause
internal damage even if the outside
appears alright. Have it checked by a
qualified electrician.
• The temperature of accessible
surfaces may be high when the
appliance is operating.

Electrical requirements

Check that the voltage on the rating
plate of your appliance corresponds
with your house electricity supply
which must be A.C. (Alternating
current).
If the socket outlets in your home are
not suitable for the plug supplied with
this appliance the plug should be
removed and the appropriate one
fitted.
WARNING : The plug removed
from the mains lead, if severed,
must be destroyed as a plug with
a bared flexible cord is hazardous
if engaged into a live socket
outlet.
WARNING: This appliance must
be earthed.
www.morphyrichards.com
g
3