Important Safeguards; Before Use - Morphy Richards TURBO Steam Quick Start Manual

Important safeguards:

This appliance can not be used by
children aged below 8 years and persons
with reduced physical, sensory or mental
capabilities or lack of experience or
knowledge, if they have been given
supervision or instruction concerning use
of the appliance in a safe way and
understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not
be made by children without supervision.
Keep the iron and its cord out of reach of
children below 8 person years of age
when it is energized or cooling down.
The iron must not be left unattended while
it is connected to the supply mains.
The plug must be removed from the
socket-outlet before the water reservoir is
filled with water.
The iron must be used and rested on a
stable surface.
When placing the iron on its heel, ensure
that the surface on which the heel is
placed is stable.
The iron is not to be used if it has been
dropped, if there are visible signs of
damage or it is leaking.

Before Use

Note:
The steam facility
should only be used on
g a r m e n t s w h i c h a r e
suitable for ironing at the 2
and 3 dot settings.
When ironing with the
steam facility at the 2 dot
setting, the steam output should be set at the
lower end of the steam range (see 'Variable
steam' section).
Textiles and clothes are supposed to carry
ironing instructions. If they don't, you should
follow the fabric guide on page 3, but be sure
to test the temperature by ironing the hem of
the garment or similar discreet area first.
If you turn the control dial down from a hot
setting to a cooler setting, wait until the iron
temperature has stabilised before you
continue ironing.
FILLING A"
"
1. Make sure that the iron
is not plugged in and
then set the variable
steam control 3 to the
'0' position before
filling the iron with
water.
2. Remove the fill cap and pour water
through the filling hole 4 into the water
tank 8, using the beaker provided. One
beaker full of water fills the tank (400ml)
A. After filling, replace the fill cap.
IN HARD WATER AREAS, THE USE OF
DISTILLED OR DEMINERALISED WATER IS
RECOMMENDED.
Never use battery topping-up fluid or water
containing any substances like starch, sugar,
fragrant additives, or defrosted water from a
refrigerator.
3. Always pour out the remaining water after
use.
WARNING:
When filling your iron with tap
water, always use the beaker provided. Never
fill directly under the tap.
Temperature control
Plug in the iron and switch
on. Set the temperature
control dial 7 to the
temperature required B,
but don't start ironing
2