Important Safety Instructions; Other Safety Considerations - Morphy Richards TURBO STEAM Dualzone Quick Start Manual

To clean a non-stick coated soleplate
(certain models only)
In the unlikely event of any man-made fibre
fusing to the soleplate, set the iron at the 3 dot
position and pass it over a clean piece of
cotton. This will draw the deposit off the
surface.
Do not use scouring powder or solution as
this could cause damage to the coating.
To clean the exterior
Allow the iron to cool and wipe over with a
damp cloth and mild detergent, then wipe
with a dry cloth.
Emptying and storing
When you have finished
ironing, unplug your iron.
Ensure that the variable
steam control is set at the
'O' position E, lift up the
filler cap and empty any
remaining water out of the
filling hole H. Do not store
in the box, but in an upright
position, so that any drops
of water remaining cannot
leak out and discolour the
soleplate.
IMPORTANT: The flex can
be damaged if wound too
tightly around the iron after
use. Make a loose loop
with the flex and wrap it
around the iron. The iron
must be cool before
winding the flex and storing
on its heel I. Use the plastic clip provided to

Important Safety Instructions

Location
Do not use outdoors or near water.
Children
Close supervision is necessary when any
appliance is used near children.
Children do not understand the dangers
associated with operating electrical
appliances.
Personal safety
WARNING:
hot metal parts, hot water or steam. Use
caution when you turn a steam iron upside
down, there may be hot water in the water
tank.
WARNING:
electric shock, do not put the appliance in
water or in any other liquid.
Do not use the vertical steam feature on
clothes that are being worn.
H
Do not leave the iron unattended whilst
plugged in or on an ironing board.
Never allow the mains lead to over hang
the work surface.
The socket should always be off before
plugging or unplugging from the socket.
Never yank the cord to disconnect from
the socket, instead, grasp the plug and
I
pull to disconnect.
Do not allow the cord to touch hot
surfaces.
Let the iron cool completely before putting
away. Loop the cord loosely around the
iron before storing.
The iron must not be left unattended while
it is connected to the supply mains.

Other safety considerations

Use the iron only for its intended use.
Always disconnect the iron from the
electrical socket when filling with water or
emptying, and when not in use.
If the supply cord is damaged, it must be
6
Burns can occur from touching
To protect against the risk of