１－２．Notes On Installation - Fastech Ezi-MotionLink Plus-E User Manual

6
Table of contents
◆ Operation & Setting change
If a protection function (Alarm) occurs, firstly remove its cause and then
release (Alarm reset) the protection function.
If you operate continuously without removing its cause, the machine may
get damaged or the user may get injured.
Make all input signals to OFF before supply input voltage to
Ezi-MOTIONLINK Plus-E. drive.
Attention
The machine may get damaged or the user may get injured by motor
operation.
All parameter values are set by default factory setting value. Change
this value after reading this manual thoroughly.
Otherwise, the machine may get damaged or other kinds of accidents may
occur.
◆ Check and Repair
Stop to supply power to the main circuit and wait sufficient time before
checking or repairing this Ezi-MOTIONLINK Plus-E.
Electricity remaining in the condenser may cause of electric shock.
Do not change cabling while power is being supplied.
Otherwise, the user may get injured or the product and machine may get
Warning
damaged.
Do not reconstruct the Ezi-MOTIONLINK Plus-E..
Otherwise, an electric shock may occur or the product and machine get
damaged. And the reconstructed product cannot get after service.
１－２．Notes on Installation
1) This product has been designed for indoor uses. The ambient temperature of the room
should be 0°~ 55°C .
2) If the temperature of drive case is 50°C or higher, radiate heat outside for cooling down.
3) Do not install this product under direct rays or near magnetic or radioactive objects.
www.fastech.co.kr