Table of Contents
Advertisement
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
•
Menu display time in the SYSTEM SETUP: Basic > Menu Settings menu sets the
length of time the OSD will remain active after your last key press. The time length
ranges from 5 to 30 seconds in 5-second increments. Use
frame.
•
Menu position in the SYSTEM SETUP: Basic > Menu Settings menu sets the OSD
position in five locations. Use
•
Language in the SYSTEM SETUP: Basic menu sets your familiar language for the
OSD menus. Use
•
Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen to be
displayed during projector start-up. Use
Shutting down the projector
1.
To turn the projector off, press POWER
OFF on the remote control to turn the
projector off directly. Or you can press
POWER on the projector and a
warning message appears. Press
POWER again.
2.
Once the cooling process finishes, the
POWER indicator light is a steady
orange and fans stop.
3.
Disconnect the power cord from the
wall socket if the projector will not be
used in an extended period of time.
•
To protect the lamp, the projector will not
respond to any commands during the
cooling process.
•
If the projector is not properly shut down,
to protect the lamp, when you attempt to re-
start the projector, the fans will run for a few minutes to cool down. Press POWER again to
start the projector after the fans stop and the POWER indicator light turns orange.
•
Lamp life results will vary depending on environmental conditions, and usage.
42
Operation
/
to select a preferred position.
/
to select your language.
/
/
to select a suitable time
to select a screen.
Hide quick links:
Advertisement
Table of Contents
