System Feature Programming - Directed 3100 Installation Manual

System Feature Programming

The system features are pre-programmed to default settings and may need to
be changed to accommodate vehicle specific requirements and user prefer-
ences. To change the system feature settings use the following procedure:
Important: Test the systems Ignition input, Door trigger input, Valet button,
Status LED, and siren for proper operation before proceeding.
1. Select a System Feature and required number of Valet button presses as
described in the following Features table.
2. Open a door, turn the key ON, and then OFF.
3. Press and release the Valet button to select the feature. After pressing
and releasing corresponding to the selected function, then press the Valet
button once more and hold it. The LED flashes and the siren sounds to
confirm the selection.
4. While still holding the Valet button press the
remote to set the feature to the LED On option. To set the LED
Off, while still holding the Valet button, press
Table)
5. Release the Valet button to exit programming, or repeat the above
to program more features.
or AUX on the 3-button remote to set the feature to
* Press
the LED Off option.
Exit Programming
The siren emits one quick chirp, and then another lengthier chirp when exiting.
Programming is exited when one of the following occurs:
• Turn ignition ON
• Close the doors
• Press Valet button too many times
• 15 seconds or more lapses between steps
12
button on the
.* (See Feature
AUX
AUX
© 2012 Directed. All rights reserved.
AUX
AUX