Sears PRO-FORM 535LE User Manual page 8

CONSOLE DIAGRAM
Note: If there is a thin sheet of clear plastic
on the face of the console, remove iL
,Pulse Sensor
I
Follow the steps below to operate the console.
B Insert the key fully into the console.
When the key is I.--,/ _-"
inserted, one indicator
F
will light in the incline t "
display, one indicator
will light in the LED
track, and the four
displays will light.
STEP-BY-STEP CONSOLE OPERATION
Before operating the
console, make sure that
the on/off switch near
the power cord is in the
on position.
Position
Next, make sure that the key is removed from the
console and then plug in the power con:l (see HOW TO
PLUG IN THE POWER CORD on page 7).
When you are ready to begin exercising, step onto the
foot rails of the treadmill. Find the clip attached to the
key (see the drawing above), and slide the clip onto
the waistband of your clothing.
B Press the SPEED _ button to start the walking
belt.
A moment after the
SPEED Z_button is
pressed, the walking belt
will begin to move. Hold
the handrails and care-
fully begin walking.
As you exercise, change the speed of the walking
belt as desired by pressing the SPEED buttons.
To stop the walking belt,
press the STOP/RESET
button. The TIME/PACE
display will begin to flash.
To restart the walking
belt, press the SPEED Z_
button again. To stop the walking belt and reset "
the displays press the STOP/RESET button for
about two seconds.