Sears PRO-FORM 535LE User Manual page 9

Table of Contents

Advertisement

_"lChange
the incline Of the treadmill as desired.
-..
To change the incline of the treadmill, press the
incline buttons. Each time one of the buttons is
pressed, the Incline will change by 0.5%. The but-
tons can be held down to change the incline rapidly.
Note: In the incline display, the first indicator will
light when the incline is set at 1.5%. The second
indicator will light when the incline is set at 2% or
2.5%, the third indicator will light when the incline
is set at 3% or 3.5%, and so forth. After the incline
buttons are pressed, it will take a moment for the
treadmill to reach the selected incline setting.
B
Follow your progress with the LED track and
the four displays.
The LED Track--
The LED track rep-
resents a distance
of 1/4 mile. As you
exercise, the indi-
cators around the
track will light one
at a time until you
j,/O09 0 0 0 0 0 O0_xL
\Oo O)
X ooooov
have completed 1/4 mile. A new lap will then begin.
DISTANCE/LAPS
display--This
display
shows the distance that
you have walked or run
and the number of laps
you have completed (one
DISTANCE
LAPS
lap equals 1/4 mile). The display will alternate
between one number and the other every seven
seconds, as shown by the arrows in the display.
TIME/PACE display--
This display shows the
elapsed time and your cur-
rent pace (pace is mea-
sured in minutes per mile).
Your pace will be shown
TIME
PACE
for a few seconds each time the speed is adjusted.
SPEED display--This
display shows the speed
of the walking belt, In
miles per hour or kilome-
ters per hour. The letters
I
1
" &B
SPEED
"MPH" dr'KPH" will ap-
pear to show which unit of measurement is selected.
To change the unit of
measurement, hold down
the STOP/RESET
button
while inserting the key
into the console. An =E,"
for english miles, or an
DISTANCE
LAPS
"M," for metric kilometers, will appear in the DIS-
TANCE/LAPS display. Press the SPEED Z_button
to change the unit of measurement.
Remove and
then reinsert the key.
CALS/FAT CALS/
PULSE display--This
display shows the ap-
proximate numbers of
calories and fat calories
you have burned (see
FAT BURNING on page 14). Every seven sec-
onds, the display will change from one number to
the other, as shown by the arrows in the display.
This display will also show your heart rate when
the pulse sensor is used (see step 5).
B
Stand on the
foot rails and
place your
thumb on the
pulse sensor as
shown. The
pulse sensor is
pressure-
activated--fully
press it down.
Do not press
too hard, or the
circulation
in
your thumb will
Measure your pulse; if desired.
Pulse Sensor
PULSE
!
-7[; 122
CALS.
FAT CALS.
be restricted,
and your pulse will not be de-
tected. Next, raise your thumb slightly until the'
•heart-shaped indicator in the CALSiFAT CALS/
PULSE display flashes steadily and a =P" appears
in the display. Hold your thumb at this level. After a
few seconds, three dashes will appear in the dis-
play and your heart rate will be shown. Hold your
thumb on the sensor for another 15 seconds for
the most accurate reading.
9

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PRO-FORM 535LE and is the answer not in the manual?

This manual is also suitable for:

831.298400

Table of Contents