AMX Modero ViewPoint MVP-8400i Operation/Reference Manual page 64

Setup Pages
Features on the Protected Setup page include:
Protected Setup Page
Back:
Connection Status icon:
Navigation Buttons:
Device Number:
Options:
System Recovery:
System Recovery (Cont.):
Reboot Panel:
Docking Station:
54
Saves all changes and returns to the previous page.
The icon in the upper-right corner of each Setup page shows online/offline state
of the panel to the master.
• Bright red - disconnected
• Bright green - connected. Blinks when a blink message is received to dark
green every 5 seconds for half a second then go back to bright green.
• Bright yellow - panel missed a blink message from the master. It will remain
yellow for 3 missed blink messages and then turn red. It will return to green
when a blink message is received.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx
Master.
The buttons along on the left side of the page provide access to secondary Pro-
tected Setup pages (see following sections).
Opens a keypad used to view/set the device number of the panel.
• Function Show - toggles the display of the channel port, channel code, level
port and level code on all touch panel buttons (see FIG. 46).
• Page Tracking - toggles the page tracking function. When enabled, the panel
reports page data to the NetLinx Master.
• Telnet - enables/disables the panel's telnet server (to allow direct telnet
communication to the panel).
• Front Button Setup Access - activates the two lower buttons on the front of
the panel for accessing the Setup and Calibration pages (see FIG. 42 on
page 51). The default setting is On.
- Press and hold these buttons for 3 seconds to access the Setup page.
- Press and hold these buttons for 6 seconds to access the Calibration page.
• Reset System Settings - deletes all of the current configuration parameters
on the panel (including IP Addresses, Device Number assignments,
Passwords, and other presets). This option invokes a Confirmation dialog,
prompting you to confirm your selection before resetting the panel.
• Remove User Pages - allows you remove all TPD4 touch panel pages
currently on the panel, including the pre-installed AMX Demo pages. This
option invokes a Confirmation dialog, prompting you to confirm your selection
before removing the panel pages.
Note that the YES button on the Confirmation dialog is disabled for 5 seconds
as additional protection against accidentally resetting the panel or removing
the panel pages.
Pressing this button causes the panel to reboot after saving any changes.
• Dock Status - illuminates when the MVP is docked and communicating with
the Docking Station.
• Undock Panel - forces the docking station to release the MVP without
requiring a User Access username or password.
• Disable Docking Station LED - disables the display of the LEDs on the
docking station.
MVP-8400i Modero Viewpoint Wireless Touch Panels