AMX Modero ViewPoint MVP-8400i Operation/Reference Manual page 103

Project Information Page (Cont.)
AMX IR 38K Port:
AMX IR 455K Port:
IR User Def 1 Port:
IR User Def 2 Port:
Build Number:
Creation Date:
Revision Date:
Last Save Date:
Blink Rate:
Job Comments:
Cradle Sensor Port:
Cradle Sensor Channel: Displays the channel assignment being used to report Cradle Sensor information.
IR receivers and transmitters on G4 panels share the device address number of the
panel.
MVP-8400i Modero Viewpoint Wireless Touch Panels
Displays the AMX 38 kHz IR channel port used by the IR Emitter on the panel.
• This information is specified in TPD4 (Project Properties > IR Emitters &
Receivers tab).
• For example if you set the AMX IR 38K Port to 7 and then put a button on the
panel with a channel code of 5 and a port of 7, it will trigger the IR code in slot 5
of the AMX IR 38K Port.
Displays the AMX 455 kHz IR channel port used by the IR Emitter on the panel.
Displays the User Defined IR channel port used by the IR Emitter on the panel.
• Note: User Defined ports can be downloaded by the user and are customizable,
whereas the AMX ones are fixed.
Displays the User Defined IR channel port used by the IR Emitter on the panel.
Displays the build number information of the TPD4 software used to create the
project file.
Displays the project creation date.
Displays the last revision date for the project.
Displays the last date the project was saved.
Displays the feedback blink rate, in .10 second increments.
Displays any comments associated to the job (from the TPD4 project file).
Displays the port assignment being used to report Cradle Sensor information.
The channel is turned on when the panel is docked (in either the TDS or WDS
docking stations.
Setup Pages
93