Table of Contents
Advertisement
Quick Links
Originalfassung
DE
BETRIESANLEITUNG
Übersetzung / Translation
EN
USER MANUAL
ES
INSTRUCCIONES DE SERVICIO
FR
MODE D'EMPLOI
SL
NAVODILA ZA UPORABO
HR
KORISNIČKI PRIRUČNIK
ACHTUNG: Öl kontrollieren!
Motor startet nicht bei Ölmindermenge!!
Edition: 18.11.2022 – Revision 00 – TrT – DE/EN/ES/FR/SL/HR
ZI-STE3000IV
EAN: 9120039232607
STROMERZEUGER
GENERATOR
GENERADOR
GROUPE ÉLECTROGÈNE
ELEKTRIČNI GENERATOR
ELEKTRIČNI GENERATOR
ATTENTION: Check Oil!
Engine don't start with low oil!!
Advertisement
Table of Contents
Related Manuals for Zipper Mowers ZI-STE3000IV
Summary of Contents for Zipper Mowers ZI-STE3000IV
- Page 1 MODE D'EMPLOI GROUPE ÉLECTROGÈNE NAVODILA ZA UPORABO ELEKTRIČNI GENERATOR KORISNIČKI PRIRUČNIK ELEKTRIČNI GENERATOR ZI-STE3000IV EAN: 9120039232607 ACHTUNG: Öl kontrollieren! ATTENTION: Check Oil! Motor startet nicht bei Ölmindermenge!! Engine don’t start with low oil!! Edition: 18.11.2022 – Revision 00 – TrT – DE/EN/ES/FR/SL/HR...
-
Page 2: Dear Customer
This manual contains information and important notes for safe commissioning and handling of the ZIPPER generator ZI-STE3000IV, hereinafter referred to as “machine” in this document. This manual is part of the machine and must not be removed. Save it for later reference and if you let other people use the machine, add this manual to the machine. -
Page 3: Intended Use Of The Machine
Persons who, due to their physical, sensory or mental capabilities, inexperience or lack of knowledge, are unable to operate the machine safely must not use the machine without supervision or instruction by a responsible person. ZIPPER MASCHINEN GmbH www.zipper-maschinen.at ZI-STE3000IV... -
Page 4: General Safety Instructions
Place the machine at least 1m away from buildings and the equipment connected to it. • • Place the machine in a secure, level position. Do not turn, tip or change the machines position while it is working. ZIPPER MASCHINEN GmbH www.zipper-maschinen.at ZI-STE3000IV... -
Page 5: Hazard Warnings
Therefore use the machine only in well-venti- lated rooms or outdoors in operation. Liquid fuels can cause serious damage on the skin and the environment. Risk of electric shock • ZIPPER MASCHINEN GmbH www.zipper-maschinen.at ZI-STE3000IV... -
Page 6: Operation
Visible transport damage must also be noted immediately on the delivery note in accordance with the provisions of the warranty, otherwise the goods are deemed to have been properly accepted. ZIPPER MASCHINEN GmbH www.zipper-maschinen.at ZI-STE3000IV... -
Page 7: Pre-Operation Check
• Pay attention to the exhaust fumes (too black, too white)? • If these points meet the demands, the machine can be used further. Otherwise stop the machine and find the cause of the problem. ZIPPER MASCHINEN GmbH www.zipper-maschinen.at ZI-STE3000IV... - Page 8 13.6 Operation 13.6.1 Switch the engine/machine on NOTE: If a device is connected to the machine, disconnect it. • Turn the fuel tap to position „ON“. • Set the ON-OFF switch (2) to position „I“. ZIPPER MASCHINEN GmbH www.zipper-maschinen.at ZI-STE3000IV...
- Page 9 In case of high power output and DC operation, the ECO-mode must always be deactivated (switch (1) in position "0"). 13.6.4 Teleskope handle • By pressing the unlocking button (2), the length of the tele- scope handle (1) can be adjusted. ZIPPER MASCHINEN GmbH www.zipper-maschinen.at ZI-STE3000IV...
- Page 10 Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. • Wipe the equipment with a moist cloth and some soft soap or blow it with compressed air at low pressure. • Take care that any water enters the interior of the machine. ZIPPER MASCHINEN GmbH www.zipper-maschinen.at ZI-STE3000IV...
-
Page 11: Maintenance
• Place the machine on a flat surface. • Loosen the screws (2) and remove the cover (1). • Open the oil drain plug (3). • Drain the old oil into a suitable container. • Close the oil drain plug (3) again. ZIPPER MASCHINEN GmbH www.zipper-maschinen.at ZI-STE3000IV... - Page 12 • Take out the air filter (4). • Clean the air filter with soapy water, then rinse with clear wa- ter and let it dry thoroughly before reassembling. • The reassembly is done in reverse order. ZIPPER MASCHINEN GmbH www.zipper-maschinen.at ZI-STE3000IV...
- Page 13 If necessary, contact your local author- ities for information regarding available disposal options. If you purchase a new machine or equivalent equipment from your specialist dealer, he is obliged in certain countries to dispose of your old machine properly. ZIPPER MASCHINEN GmbH www.zipper-maschinen.at ZI-STE3000IV...
-
Page 14: Troubleshooting
Fill engine oil • • Overload indicator light • High temperature protection Cool down the engine • glows activated • Overload protection activated • Reduce existing load • Short circuit protection acti- • Check loads vated ZIPPER MASCHINEN GmbH www.zipper-maschinen.at ZI-STE3000IV...
Need help?
Do you have a question about the ZI-STE3000IV and is the answer not in the manual?
Questions and answers