Midea MGR30S2AST Installation Instructions Manual page 14

Remove Old Appliance
WARNING
FIRE, EXPLOSION HAZARD
• Installation and service must be performed by a qualified installer, service agency or
the gas supplier.
• If the information in these instructions is not followed exactly, a fire or explosion may
result causing property damage, personal injury or death.
• IF YOU SMELL GAS:
-
Do not try to light any appliance.
-
Do not touch any electrical switch.
-
Do not use any phone in your building.
-
Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
-
If you cannot reach your gas supplier, call the fire department.
CAUTION
LACERATION, FOREIGN OBJECT, CRUSH HAZARD
• When installing, moving, or servicing any appliance, wear proper protective
equipment, including cut resistant gloves, steel-toed shoes, and safety glasses.
If the new range is replacing an existing installation, first remove the old appliance.
Directions:
• Shut off the main gas supply valve to the residence before disconnecting the old
range and leave it off until the new hookup has been completed.
• Move appliance to access the gas and electrical connections.
• Disconnect gas and electrical connections and move appliance out of and away from
installation space.
Gas Supply Requirements
WARNING
FIRE, EXPLOSION HAZARD
• Installation must conform with local codes or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA 54 or, in Canada, the Natural Gas and
Propane Installation Code, CSA B149.1
This product is equipped with a gas pressure regulator that operates at a manifold
pressure of 5" of water column for operation with natural gas or 10" of water column
when converted for operation with LP (propane).
Make sure you are supplying your range with the type of gas for which it is configured.
This range is convertible for use on natural or LP gas. When using this range on LP gas,
conversion must be made by a qualified LP installer before attempting to operate the
range.
EN-13