Electrical Connection; Building-In - JUNO JRG 90886 Operating Instructions Manual

Electrical connection

Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to your
domestic power supply.
Voltage can vary by ±6% of the rated
voltage.
For operation with different voltages, a
suitably sized auto-transformer must be
used.
Important
The appliance
earthed.
The power supply cable plug is provided
with a contact for this purpose.
If the domestic power supply socket is
not earthed. connect the appliance to a
separate earth in compliance with current
regulations, consulting a specialist
technician.
The Manufacturer
responsibility if the above safety
precautions are not observed.
This appliance complies with the
following E.E.C. Directives:
- 87/308 EEC of 2/6/87 relative to
radio interference suppression.
- 73/23 EEC of 19.2.73 (Low Voltage
Directive)
modifications.
- 89/336 EEC of 3.5.89
(Electromagnetic Compatibility Directive)
and subsequent modifications.
Attention!
It must be possible to disconnect the
appliance from the mains power supply;
the plug must therefore be easily
accessible after installation.
must
declines
and subsequent

Building-in

Dimensioned drawing
be
See "Installation Instructions"
Please check whether, after installing
your appliance and especially after
reversing the door, the door seal seals
right round. A badly fitting door seal may
lead to heavy frosting and thereby to a
higher power consumption.
all
electrolux 31
GB