Installation / Positioning / Electrical Connection - JUNO JRN 24882 Operating Instructions Manual

32 electrolux
Installation
Take utmost
handling your appliance so as
not to cause any damages to
the cooling unit with consequent
possible fluid leakages.
During normal
condenser and compressor at the
back of the appliance heat up
considerably. Always ensure that there
is adequate ventilation as a failure to
do this will result in component failure
and possible
installation instructions.
Important: if the supply cord is
damaged, it must be replaced by a
special cord or assembly available
from the manufacturer or its service
agent.
Positioning
Unpack the cabinet and check that it
is in good condition and free of any
transport damage.
The appliance must not be located
close to radiators or gas cookers.
Avoid prolonged exposure of the
appliance to direct sunlight.
For safety
ventilation must be as shown in Fig.
Attention: keep ventilation openings
clear of obstruction.
It is necessary that the niche is
provided with a conduct of venti-lation
having the following dimensions:
Depth: 50 mm
Width: 540 mm
GB
care
operation,
food loss.
reasons, minimum
when
the
The climate classification can be found
See
on the rating plate, which is located
inside the cabinet on the left hand wall.
The following table shows which ambient
temperature is correct for each climate
classification:
Climate
classification
SN
ST
Electrical connection
Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to your
domestic power supply.
Voltage can vary by ±6% of the rated
voltage.
For operation with different voltages, a
suitably sized auto-transformer must be
used.
Important
The appliance must be earthed.
The power supply cable plug is provided
with a contact for this purpose.
for an ambient
temperature of
+10 to +32 °C
N +16 to +32 °C
+18 to +38 °C
T +18 to +43 °C