Changing The Opening Direction Of The Door - JUNO JKU 6431 Operating Instructions Manual

min.
2
50cm
D546
820
870
D520
If the base plate is between 185 and 220 mm high, cut
it as shown in Fig. 12.
Fig. 13
If the base plate is
820
between 100 and
870
135 mm high, cut it
as shown in Fig. 14
and mount as des-
cribed above.
100
150
If the base plate is
between 135 and
170 mm high, cut it
as shown in Fig. 12.
Fig. 14
If the appliance has
been fitted into a spa-
ce 870 mm high and
the maximum height
of the base plate is
150 mm, fit the front
cover plate as descri-
100÷135 bed in Fig. 13.
150÷185
If the base plate is
between 150 and
185 mm high, cut it
as shown in Fig. 14.
Changing the opening direction of the
door
(Only for model JKU 6431)
Having changed the opening direction of the ap-
pliance door, it is advisable to also change the ope-
ning direction of the freezer compartment door.
To do this, proceed as follows:
D576
D577
D578
When changing the opening direction of the door,
make sure that the hinges fit properly against the sur-
face on which the door seal rests.
Fig. 15
Unscrew the two fi-
xing screws to remo-
ve the lower hinge
f ro m t h e d o o r
(Fig. 15).
Fig. 16
Remove the freezer
compartment door
and the upper hinge.
O n c e t h e f re e z e r
door has been remo-
v e d , re m o v e t h e
s c re w s f r o m t h e
catch and refit it on
the opposite side
(Fig. 16).
Fig. 17
Refit the upper hinge
and the door on the
opposite side, then
refit the lower hinge
(Fig. 17).
17