Changing The Opening Direction Of The Doors - JUNO JKG 7400 R Operating Instructions Manual

Door reversibility
1. Unplug the appliance from the power supply
before carrying out the below-mentioned
operations.
2. Remove the ventilation grill (D).
3. Remove the plug (G) and unscrew the bottom
hinge (E).
4. Remove the freezer door by releasing it from the
middle hinge (H).
5. Unscrew the middle hinge.
6. Remove the fridge door by releasing it from the
top hinge pin (A).
7. Remove the pin and the washer (A+B) from the
top hinge (C), then mount these on the opposite
side, after having removed the plugs which must
be refitted on the other side.
8. Refit the fridge door.
9. Replace the middle hinge to the left hand side.
10.Replace the freezer door.
11. Screw down the bottom hinge (E) on the opposite
side by using the screws previously removed.
12.Refit the plug (G) on the bottom hinge . Remove
the plug (F) from the ventilation grill (D) and
replace it on the opposite side.
13.Re-assemble the ventilation grill (D).
14.Unscrew the handles. Refit it on the opposite
side after having piercing the plugs with a punch.
Cover the holes left open with the plugs
contained in the documentation pack.
The doors can be aligned by adjusting both the
middle and top hinges.
The middle hinge can be adjusted horizontally, with
the help of a tool, after having slackened the two
screws.
The top hinge is adjusted by slackening the nut with
a 10 mm spanner and then proceeding as shown in
the Figure.
Warning:
After having reversed the opening direction of
the doors check that all the screws are properly
tightened and that the magnetic seal adheres to
the cabinet. If the ambient temperature is cold (i.e.
in Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of the
gasket or accelerate this process by heating up the
part involved with a normal hairdrier.
PR19
H
PR24
E
F
D
F
PR18
PR220
C
B
A
G
E
F
19