Table of Contents
Advertisement
Door reversal
1. Pull off the ventilation grille (D), which is a clip-on
fit. Remove the bottom hinge (E) by unscrewing its
two fixing screws.
2. Remove the plugs (G) and fit them on the opposite
side.
3. Remove the door (4).
4. Unscrew pin (2) and screw it onto the opposite
side.
5. Refit the door.
6. Refit the bottom hinge on the opposite side using
the two screws previously removed.
7. Slide the hole cover (F) off the ventilation grille (D)
and fit it on the opposite side.
8. Refit the ventilation grille, clipping it into place.
9. Remove the clip-in screw covers, then move the
handle to the opposite side. Holes which are not
used must be masked with the plastic plugs
previously removed from the opposite side.
Warning!
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting
of the gasket or accelerate this process by
heating up the part involved with a normal
hairdrier.
Installation
Take utmost care when handling your
appliance so as not to cause any damages to
the cooling unit with consequent possible fluid
leakages.
¥ During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
¥ Important: if the supply cable is damaged, it must
be replaced by authorized service or qualified
personnel using a special cable of the same type.
Positioning
¥ Unpack the cabinet and check that it is in good
condition and free of any transport damage.
¥ Place the refrigerator away from direct sunlight and
heat sources.
¥ Avoid prolonged exposure of the appliance to
direct sunlight.
¥ For safety reasons, minimum ventilation must be
as shown in Fig.
n .
m i
2
m
5 0 c
PR215
Attention: keep ventilation openings clear of
obstruction.
¥ Two adjustable feet at the cabinet base allow
accurate levelling of the appliance.
The climate classification can be found on the rating
plate, which is located inside the cabinet on the left
hand wall.
15
Advertisement
Table of Contents
