Maintenance And Care; Storage; Disposal And Recycling; Troubleshooting - Scheppach AERO2 SPADE Instruction Manual

At the end of work:
• Interrupt the compressed air supply.
• Remove the tool from the device.
• Check that the tool receiver has been furnished
with an oil film.
• If this is not the case, introduce a few drops of spe-
cial oil into the connection hose and operate the
device without tool for ca. 15 seconds.
• Clean the compressed air device, the tools, the
hose and any other accessories with a dry or oily,
clean cloth.

13. Maintenance and care

If the regular oil supply to the device is assured, the
device is maintenance-free.
Clean the device at regular intervals.
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Application tools
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from
our service centre. To do this, scan the QR code on
the cover page.

16. Troubleshooting

Problem
Compressed air device does not
start or lacks power
Tool no longer latches into the
tool receiver or does not lock into
place
Tool cannot be inserted or
removed
Device operates continuously
without the trigger lever being
actuated
Possible Cause
Piston jammed (rusted) in the housing
due to a lack of oil
Dirt has penetrated via the air hose
Too much lubricating oil used or wa-
ter in the striking mechanism
Pressing force too high
Output power of the air source too
low
Tool or tool receiver worn out. (Most
often caused by excessive pressure
or no-load strokes)
Dirt in the sliding sleeve prevents
unlocking
Valve defective
www.scheppach.com

14. Storage

Note
• Store the device in a dry and frost-free location
(10-25 °C).
• Fertiliser and other garden chemicals contain sub-
stances that can have a severely corrosive effect
on the metal parts. Do not store the device in the
vicinity of these substances.

15. Disposal and recycling

Notes for packaging
The packaging materials are
recyclable. Please dispose of
packaging in an environmen-
tally friendly manner.
You can find out how to dispose of the disused
device from your local authority or city adminis-
tration.
Help
• Press the piston back with a striking bolt
through the tool receiver
• Introduce a little oil into the connection
hose and into the tool receiver
• Run the device briefly without a tool
• Repeat this process a few times
Repair must be carried out by a specialist
workshop
Run the device briefly without a tool
Grease tool receiver and reduce pressing
force
Use an air source with a higher output
power
Repair must be carried out by a specialist
workshop
Repair/cleaning must be carried out by a
specialist workshop
Repair must be carried out by a specialist
workshop
GB | 23