D-Link SECURICAM NETWORK DCS-5300 User Manual page 94

Using IP surveillance Software (continued)
Monitor Program (continued)
IP surveillance includes pan/tilt control, DI/DO (Digital Input / Digital Output)
control, and an alert message receiver. Each of these are described in detail
below.
P/T Control
Refer to the following figure to use the pan and tilt controls.
Tilt/navigate camera using arrows.
Pan – Pans the camera one full cycle.
Stop – Stops movement of the camera during pan.
Patrol – Enables the Auto Patrol feature.
Pull down menu –
DI/DO Control
Clicking on the "DI/DO" button shown below, you can switch to the DI/DO
controls. The color of the channel number indicates the status of the camera's
DI (Digital Input). You can click the "Switch button" to change the HI/LOW state
of the DO (Digital Output). With these features, you can monitor the remote
sensor input from DI and also trigger the camera by DO switch
Set digital output to LOW
Set digital output to HIGH
When the color of a DI/DO number is gray, that means the video has not yet
been connected to a camera.
Return to home position.
Select a preset position to move the camera to.
94
.
No connection