The Clean Air Act 1993 And Smoke Control Areas - Cast Tec Solid Fuel Integra Installation And Operating Instructions Manual

THE CLEAN AIR ACT 1993 AND SMOKE CONTROL AREAS

The Cast Tec Solid Fuel Integra Eco has been recommended as suitable for use in smoke
control areas when burning wood logs. The Cast Tec Solid Fuel Integra Eco is factory
fitted with a permanent stop to prevent complete closure of the Primary and Secondary Air
controls.
Under the Clean Air Act local authorities may declare the whole or part of the district of the
authority to be a smoke control area. It is an offence to emit smoke from a chimney of a
building, from a furnace or from a fixed boiler if located in a designated smoke control area.
It is also an offence to acquire an "unauthorised fuel" for use within a smoke control area
unless it is used in an "exempt appliance ("exempted" from the controls which generally
apply in the smoke control area)
In England appliances are exempted by publication on a list by the Secretary of State in
accordance with changes made to sections 20 and 21 of the Clean Air Act 1993 by
section 15 of the Deregulation Act 2015. Similarly, in Scotland appliances are exempted
by publication on a list by Scottish Ministers under section 50 of the Regulatory Reform
(Scotland) Act 2014.
In Wales and Northern Ireland these are authorised by regulations made by Welsh
Ministers and by the Department of the Environment respectively.
Further information on the requirements of the Clean Air Act can be found here:
https://www.gov.uk/smoke-control-area-rules
Your local authority is responsible for implementing the Clean Air Act 1993
including designation and supervision of smoke control areas and you can contact
them for details of Clean Air Act requirements.
2
Solid Fuel Inset's instructions Cast Tec Ltd