Manual Tuning - Aiwa CA-DW935 Operating Instructions Manual

MANUAL TUNING
MODE
BAND
+,-
TUNERMODE/
1
2
Press the TUNEFUBAND button on the main unit
or the BAND button on the remote control
repeatedly to select the desired band.
m
When the TUNER/BAND button is pressed while the power is
off, the power is turned on and the previously tuned station is
received (Direct Play Function).
Press the 44 or W button to select a station.
Each time the button is pressed, the frequency changes.
During FM stereo reception, STEREO is displayed.
To search for a station quickly (Auto Search)
Keep the ++ or - button pressed until the tuner starts
searching for a station. After tuning in to a station, the search
stops.
To stop the Auto Search manually, press the 4+ or - button.
The Auto Search may not stop at stations with very weak signals.
For better reception
FM
Extend the rod antenna and orient it for the best reception.
AM
The antenna is inside the unit. Position the unit for the best
reception.
When an FM stereo broadcast contains noise
Press the TUNER MODE/OSC button on the main unit or the
MODE button on the remote control.
MONO appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, repeat the above again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHzLstep, change the tuning interval.
Press the POWER button while pressing the TUNER/BAND
button.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations (see
"PRESETTING STATIONS) are cleared. The preset stations
have to be set again.
kl!lu~ l!!-
.. --_=-.
6
ENGLISH