The Timer; Setting The Timer - Aiwa CA-DW935 Operating Instructions Manual

SETTING THE TIMER
POWER~
The unit can be turned on at a specified time every day with the
built-in timer.
Set the timer as follows while the power is on.
Preparation
Make sure the clock is set correctly,
To record the selected source onto a tape
using the
timer function
Before beginning the timer setting, insert a tape to be recorded
into deck 1, then start from step 1.
7 Press the TIMER button to display ~, and press
the II button within 4 seconds.
@
and the hour flash.
2
3
w
If you do not press the 1I button within 4 seconds, another
operation may start.
Designate the hour of the timer-on time by
pressing the < or + button, and press the
11 button.
Repeat this to designate the minute of the timer-
on time.
Select the duration for the timer-activated period
with the < or > button, and press the II
button.
4
5
6
Prepare the source.
To
listen to a CD,
press the CD button and load the disc.
To
listen to the radio,
press the TUNER/BAND button and
tune in to a station.
To listen to a tape,
press the TAPE button, insert a tape into
deck 1 or 2, and press the F button for the corresponding
deck to start play.
To
listen to the equipment connected to the AUX/VIDEO
jacks,
press the AUX button and set the timer of the connected
equipment (with an external timer) and prepare for the play.
Adjust the volume and press the POWER button
to turn the unit off.
@
remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 21 when the power is
turned off with the volume level set to 22 or higher.
For timer recording: Press the button for the
deck 1.
The > button is pressed simultaneously.
To check the specified time
Press the TIMER button. The timer-on time and the duration for
the timer-activated period flash for 4 seconds.
To
cancel timer standby
mode temporarily
Press the TIMER button twice to turn off 0.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 4 to prepare the source,
and adjust the volume.
m
. Timer playback will not begin unless the power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
14
ENGLISH