(1) Dismantle the screws*2
(M3*L6) to loose the EX-AWIN
BD .(Figure1)
8
(2) Dismantle the STAND
OFF(M3 D6*9L) and screws*2
(M3*L6) on M/B.(Figure2,3)
(1) Dismantle the Grounding
9
screw*1(M4*L6) in the shield and
loose the Grounding wire.
(1) Dismantle the screws*4
(M3*L8) connecting the PowerBD
shield and the L/C, then take off
the shield.(Figure1)
10
(2) Take off the inlet case
following the way indicated as
Figure2, then extract all the wires
in the power board.
(3) Take off the power board
(Figure3).
Figure1
EX-AWIN BD
Note: Circuit boards > 10cm
rectangle as above image shows. Please detach the Circuit boards
and follow local regulations for disposal.
Figure1
4
2
Figure2
Figure3
Note: Circuit boards > 10cm
rectangle as above image shows. Please detach the Circuit boards
and follow local regulations for disposal.
40
Figure2
2
has been highlighted with the yellow
1
3
2
has been highlighted with the yellow
Figure3
screw
driver
screw
driver
screw
driver