Table of Contents
Advertisement
When mounting to a ceiling
Through the two holes on each side of the camera base,
insert the supplied two screws to corresponding holes and
secure them with a screwdriver�
When mounting to a wall
■ Attach the alignment sticker to the wall�
■ Through the two circles on the sticker, drill two pilot holes into the wall�
■ Hammer the supplied plastic anchors into the holes�
■ Align the two holes on each side of the camera base with the two
plastic anchors on the wall, insert the supplied screws to corresponding
holes and secure them with a screwdriver�
3� Feed power to the Network Camera and connect it to the Internet� For more information,
please refer to Network Deployment on page 9 for details�
4. Install the "Installation Wizard 2" to assign IP address to the Network Camera. For more
information, please refer to Software Installation on page 12 for details�
5� Access to the Network Camera from the Internet� For more information, please refer to
Accessing the Network Camera on page 13 for details�
6� It is suggusted to select Fix Iris in the Audio and Video page (Choose Configuration >
Advanced Mode > Audio and video) to set up the iris at the maximum value; then follow the
instustions on the next page to adjust the zoom factor and focus range. Upon completion,
uncheck this item to enable auto iris�
7� Based on the live image retrieved from the camera, adjust the camera lens as following steps�
To adjust the viewing angle
■ Loosen the pan screw , then turn the lens module left and right� Upon completion,
tighten the pan screw�
■ Loosen the tilt screws on both side of the camera , then turn the lens module up and
down� Upon completion, tighten the tilt screws�
■ Loosen the image adjustment screw , then turn the lens to adjust the image orientation�
Upon completion, tighten the image adjustment screw�
Int.
Ext.
In
Mic.
Out
Audio
4
3
2
1
I/O
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
1
Int.
Ext.
In
Mic.
Out
Audio
4
3
2
2
1
Int.
Ext.
In
Mic.
Out
Audio
I/O
Alignment sticker
4
3
2
1
I/O
3
Rotate the screw
Turn the lens
User's Manual - 7
Advertisement
Table of Contents
