Vivotek 4X-FD7132 Quick Installation Manual
  1. Manuals
  2. Brands
  3. Vivotek Manuals
  4. Security Camera
  5. 4X-FD7132
  6. Quick installation manual
Vivotek 4X-FD7132 Quick Installation Manual

Vivotek 4X-FD7132 Quick Installation Manual

Day & night indoor 3 axis poe pir
Hide thumbs Also See for 4X-FD7132:
Table of Contents

Advertisement

Quick Links

Download this manual See also: User Manual

Advertisement

Table of Contents
loading

Related Manuals for Vivotek 4X-FD7132

Summary of Contents for Vivotek 4X-FD7132

  • Page 2 Contact your distributor when such cases happen. Contact your distributor when such cases happen. EN - 1...
  • Page 3 EN - 2...
  • Page 4 EN - 3...
  • Page 5 Lens Tilt screw Built-in microphone PIR sensor Indented reset button Image adjustment screw Pan screw 1 2 3 4 Audio Out Mic. In Ext. Int. Audio out General I/O terminal block Drill holes Dome cover EN - 4 Light sensor IR LEDs Status LED Ethernet 10/100 RJ45 socket...

  • Page 6: Installation Tips

    First, use the supplied screwdriver to detach the dome cover from the camera base. Then, follow the steps below to install the camera; either to a ceiling or to a wall. Installation Tips Before installing the camera, look for a spot that best suits your needs. The built-in PIR sensor is designed to be triggered when a person enters its detection range.

  • Page 7: General Connection (Without Poe)

    General Connection (without PoE) 1. If you have external devices such as sensors and alarms, make connections from gen- eral I/O terminal block. 2. Connect the camera to a switch via a Ethernet cable. 3. Connect the supplied power cable from the camera to a power outlet. 1 2 3 4 Ethernet switch Audio Out...

  • Page 8: Power Over Ethernet (Poe)

    Power over Ethernet (PoE) The camera is PoE-compliant, allowing transmission of power and data via single Ether- net cable. See the following illustration to connect the camera to a PoE-enabled switch via Ethernet cable. PoE switch Use a PoE power injector (optional) to connect between the camera and a non-PoE switch.
  • Page 9 1. Install the "Installation Wizard 2" under the Software Utility directory from software CD. 2. The program will conduct analyses on your network environment. After your network is analyzed, please click on the "Next" button to continue the program. Installation Wizard 2 3.
  • Page 10 1. Access to the Network Camera from the Internet. 2. Retrieve live video through web browsers or recording software. 3. It is suggusted to select Fix Iris in the Audio and Video page (Choose Configuration > Advanced mode > Audio and video) to set up the iris at the maximum value; then fol- low the instructions on the next page to adjust the zoom factor and focus range.

  • Page 11: To Adjust The Zoom Factor And Focus Range

    Based on the live image retrieved from the camera, adjust the camera lens by doing the following: To adjust the viewing angle 1. Loosen the pan screw and then turn the lens module left and right. Upon completion, tighten the pan screw. 2.
  • Page 12 Attach the dome cover to camera. Secure the two dome screws with a screwdriver. Finally, make sure all parts of the camera are securely installed. The supplied screwdriver is exclusively designed to match the dome screws. In case you will need to adjust the lens at a later time, do not discard the screwdriver.
  • Page 13 P/N: 625006600G Ver.1.01 Copyright 2008 VIVOTEK INC. All right reserved.

Table of Contents