Reloading The Firmware - 3Com OfficeConnect 3C16771 User Manual

164 A
PPENDIX
4 Continue holding the reset button in until the Alert LED
starts flashing. This should be approximately 20 seconds.
5 When the Alert LED stops flashing, the reset is complete.
You can now release the reset button.
When the reset is complete, the Internet Firewall restarts.
The Power LED stops flashing and the Alert LED is
illuminated continuously, indicating that the unit has been
reset and the firmware erased.

Reloading the Firmware

Even when the firmware has been erased, you can use a
basic web management interface to get the Internet
Firewall up and running again. The Internet Firewall reverts
to its default IP address of 192.168.1.254 after a complete
reset, so you must reconfigure your chosen management
station to an IP address in the same subnet to access the
management interface (for example, 192.168.1.200, as
described on page 38).
To reload the firmware:
1 Type http://192.168.1.254 into the web browser on
the management station, and press Enter. The basic
management interface loads, similar to that shown in
Figure
G: R I
ESETTING THE NTERNET
53.
F
IREWALL